Installing or removing the bit, Depth gauge

Installing or removing the bit

The bit can be secured at the desired angle. To change the bit angle, rotate the action mode changing knob to the O symbol. Turn the bit to the desired angle.

1 2

003150

1. Bit shank

2. Bit grease

Rotate the action mode changing knob to the symbol. Then make sure that the bit is securely held in place by turning it slightly.

Clean the bit shank and apply bit grease before installing the bit.

1. Bit

010714

Insert the bit into the tool. Turn the bit and push it in until it engages.

After installing, always make sure that the bit is securely held in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way and pull the bit out.

010728

Depth gauge

The depth gauge is convenient for drilling holes of uniform depth.

1	2	1. Grip base
	2	2.	Lock button
		2.	Lock button
		3.	Depth gauge
3
010716

010715

1.Bit

2.Chuck cover

Press the lock button on the grip base in the direction of arrow shown in the figure and with the lock button being pressed insert the depth gauge into the hex. hole in the grip base

	1	1. Toothed side of
	1	hex hole
		marking on the
	2	grip base
	2	2. Toothed side of
		2. Toothed side of
		the depth gauge

Bit angle (when chipping, scaling or demolishing)

For Models HR2310T, HR2610, HR2610T, HR2611F, HR2611FT

1. Action mode changing knob

010727

010717

At this time, the depth gauge needs to be inserted so that its toothed side is directed to the toothed side of hex hole marking on the grip base as shown in the figure.