wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock.
4. | Wear a hard hat (safety helmet), safety glasses |
| and/or face shield. Ordinary eye or sun |
| glasses are NOT safety glasses. It is also |
| highly recommended that you wear a dust |
| mask and thickly padded gloves. |
5. | Be sure the bit is secured in place before |
FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
Switch action
operation. |
6. Under normal operation, the tool is designed |
to produce vibration. The screws can come |
loose easily, causing a breakdown or accident. |
Check tightness of screws carefully before |
operation. |
7. In cold weather or when the tool has not been |
used for a long time, let the tool warm up for a |
while by operating it under no load. This will |
loosen up the lubrication. Without proper |
1
2
010720
CAUTION:
1.Switch trigger
2.Lock button
| |
8. | Always be sure you have a firm footing. |
| Be sure no one is below when using the tool in |
| high locations. |
9. | Hold the tool firmly with both hands. |
10. | Keep hands away from moving parts. |
11. | Do not leave the tool running. Operate the tool |
| only when |
12. | Do not point the tool at any one in the area |
| when operating. The bit could fly out and |
| injure someone seriously. |
13. | Do not touch the bit or parts close to the bit |
| immediately after operation; they may be |
| extremely hot and could burn your skin. |
14. | Some material contains chemicals which may |
| be toxic. Take caution to prevent dust |
| inhalation and skin contact. Follow material |
| supplier safety data. |
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.
•Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop the tool from the locked position, pull the switch trigger fully, then release it.
Lighting up the lamps
For Models HR2611F, HR2611FT
1. Lamp
1
010721
CAUTION:
•Do not look in the light or see the source of light directly.
To turn on the lamp, pull the trigger. Release the trigger to turn it off.
NOTE:
•Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination.
•Do not use thinner or gasoline to clean the lamp. Such solvents may damage it.
4