Makita HR2611F Operation, Hammer drilling operation, Blow-out bulb optional accessory

Page 9

1

24

3

1.Inside periphery

2.Carved side

3.Attachment

4.Cap

5.Groove

OPERATION

Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations.

Hammer drilling operation

5

012895

1

2

012896

1.Cap

2.Attachment

010729

Set the action mode changing knob to the symbol. Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. Light pressure gives best results. Keep the tool in position and

NOTE:

When installing or removing the dust cup, the cap may come off the dust cup. At that time, proceed as follows. Remove the bellows from the attachment and fit the cap from the side shown in the figure with its carved side facing upward so that the groove in the cap fits in the inside periphery of the attachment. Finally, mount the bellows that has been removed.

011505

NOTE:

If you connect a vacuum cleaner to your hammer, cleaner operations can be performed. Dust cap needs to be removed from the dust cup before the connection.

prevent it from slipping away from the hole.

Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed.

Set the action mode changing knob to the symbol.

CAUTION:

There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole break-through, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Failure to do so may result in the loss of control of the tool and potentially severe injury.

NOTE:

Eccentricity in the bit rotation may occur while operating the tool with no load. The tool automatically centers itself during operation. This does not affect the drilling precision.

Blow-out bulb (optional accessory)

1. Blow-out bulb

1

002449

9

Image 9
Contents Rotary Hammer Combination Hammer Symbols SpecificationsPower supply English Original instructionsCould result in a hazardous situation Rotary Hammer Safety WarningsSwitch action Functional DescriptionLighting up the lamps Reversing switch action Selecting the action modeChanging the quick change chuck for SDS-plus Torque limiter AssemblySide grip auxiliary handle Bit greaseBit angle when chipping, scaling or demolishing Installing or removing the bitAction mode changing knob Depth gaugeSymbol Installing or removing the dust cupDust cup Dust cupBlow-out bulb optional accessory OperationHammer drilling operation Drilling in wood or metal Chipping/Scaling/DemolitionFor Models HR2300, HR2600, HR2601, HR2610 HR2611FMaintenance Optional AccessoriesOperation when using the dust cup accessory Diamond core drillingMakita Corporation