Miller Electric 3035, 3545 manual Removing Existing Barrel And Installing Contact Adapter

Page 16

3-5. Removing Existing Barrel And Installing Contact Adapter

	4
	3
	5
	2
	1
	4
6
7	3
	2
Tools Needed:
12 mm

1Base Nut Location Remove base nut from handle.

2Handle Section

Remove handle section from gun.

3Drive Roll Assemblies

Remove drive roll assemblies.

4Nut

Remove nut from barrel.

5 Barrel

Remove barrel from gun. Disconnect gas hose from gas nipple.

6Antirotation Pin

7Contact Adapter

Remove antirotation pin from contact adapter.

Install contact adapter into gun, and secure with nut.

Reinstall drive roll assemblies. Reinstall handle section onto gun. Reinstall base nut onto handle.

802 379-B

OM-1216 Page 12

Image 16

Contents Spoolmate File Wire Feeder OM-1216205 917DProcesses DescriptionFrom Miller to You Table of Contents Page Symbol Usage Marks a special safety messageArc Welding Hazards Electric Shock can killARC Rays can burn eyes and skin Welding can cause fire or explosionFlying Metal can injure eyes Buildup of GAS can injure or killCalifornia Proposition 65 Warnings EMF Information Principal Safety StandardsAbout Pacemakers LES Fumées ET LES GAZ peuvent être dangereux UNE Décharge Électrique peut entraîner la mortIndique un message de sécurité particulier LE Soudage peut provoquer un Incendie ou une explosionDES Particules Volantes peuvent blesser les yeux DES Pièces Chaudes peuvent provoquer des brûlures gravesRisque D’INCENDIE OU D’EXPLO LA Chute DE L’APPAREIL peut blesser’EMPLOI Excessif peut SUR DES Organes Mobiles peuvent provoquer des blessuresPrincipales normes de sécurité En ce qui concerne les stimulateurs cardiaquesSpecifications For Spoolmate Approximate Cooling Maximum Spool Weld Circuit OverallConnecting Spool Gun To Millermatic Rear PanelInstalling Wire Spool And Threading Welding Wire Screw rotation clockwise decreasesRemoving Existing Barrel And Installing Contact Adapter Routine Maintenance ControlsTurn Off power at welding Power source first Changing Drive RollsChanging Push Roll Changing Lower Drive RollTroubleshooting Changing LinerOM-1214 − Electrical Diagrams − Parts List Optional Hardware is common and not available unless listed Push Roll .047 1.2 mm Spoolmate Optional Hose & Cables Extension Kit 194 996 -3. Spoolmate Hose & Cables Extension KitService SupportOwner’s Record Miller Electric Mfg. Co