Miller Electric 3035, 3545 manual Connecting Spool Gun To Millermatic, Rear Panel

Page 14

3-3. Connecting Spool Gun To Millermatic 210

4

3

5

6

Rear

Panel

		1	Barbed Fitting
1	2	. If spool gun			gas	hose is
	2		equipped with a pre-installed
			equipped with a pre-installed
			barbed fitting, cut off fitting from
			end of hose.
		Connect spool gun gas hose to
		barbed fitting.
		2	Gun Trigger Plug
		Insert plug into receptacle labeled
		“SPOOL		GUN”,	and	tighten
		threaded collar.
		3	Negative (−) Output Terminal
		4	Positive (+) Output Terminal
		Connect spool gun weld cable to
		positive (+) output terminal.
		Close door.
		5	Welding Power Source Gas
			Hose Connection For Spool
			Gun
		6	Welding Power Source Gas
			Hose Connection For MIG
			Gun
		Connect		gas hose		between
		regulator/flowmeter			gas hose
		connection, and fitting on rear of
		welding power source.

802 998-C

OM-1216 Page 10

Image 14

Contents Processes Spoolmate File Wire FeederOM-1216205 917D DescriptionFrom Miller to You Table of Contents Page Arc Welding Hazards Symbol UsageMarks a special safety message Electric Shock can killFlying Metal can injure eyes ARC Rays can burn eyes and skinWelding can cause fire or explosion Buildup of GAS can injure or killCalifornia Proposition 65 Warnings About Pacemakers Principal Safety StandardsEMF Information Indique un message de sécurité particulier UNE Décharge Électrique peut entraîner la mortLES Fumées ET LES GAZ peuvent être dangereux DES Particules Volantes peuvent blesser les yeux LE Soudage peut provoquer unIncendie ou une explosion DES Pièces Chaudes peuvent provoquer des brûlures graves’EMPLOI Excessif peut SUR Risque D’INCENDIE OU D’EXPLOLA Chute DE L’APPAREIL peut blesser DES Organes Mobiles peuvent provoquer des blessuresPrincipales normes de sécurité En ce qui concerne les stimulateurs cardiaquesSpecifications For Spoolmate Approximate Cooling Maximum Spool Weld Circuit OverallConnecting Spool Gun To Millermatic Rear PanelInstalling Wire Spool And Threading Welding Wire Screw rotation clockwise decreasesRemoving Existing Barrel And Installing Contact Adapter Routine Maintenance ControlsChanging Push Roll Turn Off power at welding Power source firstChanging Drive Rolls Changing Lower Drive RollTroubleshooting Changing LinerOM-1214 − Electrical Diagrams − Parts List Optional Hardware is common and not available unless listed Push Roll .047 1.2 mm Spoolmate Optional Hose & Cables Extension Kit 194 996 -3. Spoolmate Hose & Cables Extension KitService SupportOwner’s Record Miller Electric Mfg. Co