Miller Electric 3545, 3035 manual Controls, Routine Maintenance

Page 17

SECTION 4 − OPERATION

4-1. Controls

2

1


		. Spool Gun			On/Off	switch in
			Millermatic		185	Hobart
			IronMan 210 or IronMan 250
			must be in On position for spool
			gun operation (see Field Kit
			207 642 instructions).
		1	Shielding Gas Cylinder
		For shielding gas connections, see
		welding		power	source	Owner’s
		Manual.
		2	Valve
		Open valve on cylinder just before
		welding.
		3	Trigger
		Press trigger to energize welding
		power		source	contactor, start
		shielding gas flow, and begin wire
		feed.
	3	Wire feed speed is controlled by
	3	welding power source Wire Speed
		welding power source Wire Speed
		control		(see appropriate welding
		power source Owner’s Manual).

Close valve on cylinder when finished welding.

sb5.1* 6/92 − S-0621-C / 804 386-A

SECTION 5 − MAINTENANCE & TROUBLESHOOTING

5-1. Routine Maintenance

			Y Disconnect power	. Maintain more often
			before maintaining.	during severe conditions.
n = Check	Z = Change	~ = Clean	l = Replace	Reference
* To be done by Factory Authorized Service Agent

Every l Unreadable Labels	~ Weld Terminals	l Damaged Gas Hose	nl Weld Cables
3
Months

	nl Cords	nl Gun Cables
	Every
	6	OR
	Months	OR
	Months
	~ Drive Rolls	~ Inside Unit

OM-1216 Page 13

Image 17

Contents OM-1216205 917D Spoolmate File Wire FeederProcesses DescriptionFrom Miller to You Table of Contents Page Marks a special safety message Symbol UsageArc Welding Hazards Electric Shock can killWelding can cause fire or explosion ARC Rays can burn eyes and skinFlying Metal can injure eyes Buildup of GAS can injure or killCalifornia Proposition 65 Warnings About Pacemakers Principal Safety StandardsEMF Information Indique un message de sécurité particulier UNE Décharge Électrique peut entraîner la mortLES Fumées ET LES GAZ peuvent être dangereux Incendie ou une explosion LE Soudage peut provoquer unDES Particules Volantes peuvent blesser les yeux DES Pièces Chaudes peuvent provoquer des brûlures gravesLA Chute DE L’APPAREIL peut blesser Risque D’INCENDIE OU D’EXPLO’EMPLOI Excessif peut SUR DES Organes Mobiles peuvent provoquer des blessuresEn ce qui concerne les stimulateurs cardiaques Principales normes de sécuritéApproximate Cooling Maximum Spool Weld Circuit Overall Specifications For SpoolmateRear Panel Connecting Spool Gun To MillermaticScrew rotation clockwise decreases Installing Wire Spool And Threading Welding WireRemoving Existing Barrel And Installing Contact Adapter Controls Routine MaintenanceChanging Drive Rolls Turn Off power at welding Power source firstChanging Push Roll Changing Lower Drive RollChanging Liner TroubleshootingOM-1214 − Electrical Diagrams − Parts List Optional Hardware is common and not available unless listed Push Roll .047 1.2 mm 194 996 -3. Spoolmate Hose & Cables Extension Kit Spoolmate Optional Hose & Cables Extension KitSupport ServiceMiller Electric Mfg. Co Owner’s Record