Miller Electric D-64 manual Directives, Standards

Page 4

Declaration of Conformity for

European Community (CE) Products

Note This information is provided for units with CE certification (see rating label on unit).

Manufacturer’s Name:

Manufacturer’s Address:

Declares that the product:

Miller Electric Mfg. Co.

1635 W. Spencer Street Appleton, WI 54914 USA

D-64

conforms to the following Directives and Standards:

Directives

Low Voltage Directive: 73/23/EEC

Electromagnetic Compatibility (EMC) Directive: 89/336/EEC

Machinery Directives: 89/392/EEC, 91/368/EEC, 93/C 133/04, 93/68/EEC

Standards

Arc Welding Equipment Part I: Welding Power Sources: IEC 60974-1

(September 1998 – Second Edition)

Arc Welding Equipment: Wirefeed Systems: IEC 974-5

(September 1997 – Draft Revision)

Degrees of Protection Provided By Enclosures (IP Code): IEC 529

(November 1989 – First Edition)

Insulation Coordination For Equipment With Low-Voltage Systems:

Part I: Principles, Requirements and Tests: IEC 664-1

(October 1992 – First Edition)

Electromagnetic Compatibility, (EMC): EN 50199

(August 1995)

European Contact: Mr. Danilo Fedolfi, Managing Director

MILLER Europe S.r.l.

Via Privata Iseo

20098 San Giuliano

Milanese, Italy

Telephone: 39(02)98290-1

Fax: 39(02)98281-552

dec_con 11/96

Image 4

Contents Processes OM-1582Description From Miller to You Table of Contents Directives StandardsSymbol Usage Marks a special safety messageArc Welding Hazards Electric Shock can killARC Rays can burn eyes and skin Welding can cause fire or explosionFlying Metal can injure eyes Buildup of GAS can injure or killPrincipal Safety Standards EMF Information About PacemakersSignification des symboles Consignes DE Securite Lire Avant UtilisationUN Choc É Lectrique peut tuer LES Fumé ES ET LES GAZ peuvent ê tre dangereuxDES Particules Volantes peuvent blesser les yeux LE Soudage peut provoquer un incendie ou une explosionLE Bruit peut affecter l’ouïe Risque D’INCENDIE OU LA Chute DE L’APPAREIL peut blesser’EMPLOI Excessif peut DES Organes Mobiles peuvent provoquer des blessuresInformation sur les champs é lectromagné tiques Principales normes de sé curitéConsignes relatives aux stimulateurs cardiaques + + + DefinitionsSymbols And Definitions Rating Label For CE ProductsInstallation SpecificationsIntroduction Site SelectionEquipment Connection Diagrams Gun Recommendation TablePin Plug Information Rear Panel ConnectionsPin Information Motor Speed Wire Type Wire Size Feed Speed Capability Wire Type, Size, And Feed Speed Capability TableMotor Start Control Rotating The Drive Assembly Installing And Threading Welding Wire To adjust drive roll pressure, hold nozzleOptional Equipment DIP Switch Settings Spot Time Range SelectionOption Interface Standard SettingsOperation Front Panel ControlsMaintenance and Troubleshooting Routine MaintenanceDisconnect power before maintaining Overload Protection And Optional Side Panel ControlsDisconnect power before troubleshooting TroubleshootingTrouble Remedy OM-1582 Electrical Diagram Circuit Diagram197 518-A Parts List Main AssemblyOptional Control Box Control Box -1 Item Panel, Front w/Components Panel, Front w/Components -2 Item Control Panel Drive Assembly, Wire Drive Assembly, Wire -1 Items 15 Kit Roll Wire Size Drive Roll And Wire Guide Kits Fraction MetricRoll Drive OM-1582 Service SupportOwner’s Record Miller Electric Mfg. Co