Miller Electric Bobcat 250 manual Servicing Air Cleaner Robin-Powered Units

.A complete Parts List is available at www.MillerWelds.com

8-3. Servicing Air Cleaner (Robin-Powered Units)

1

2

! Stop engine.

NOTICE − Do not run engine with- out air cleaner or with dirty element.

1 Precleaner

Wash precleaner with soap and wa- ter solution. Allow precleaner to air dry completely.

Spread 1 tablespoon SAE 30 oil evenly into precleaner. Squeeze out excess oil.

2 Element

Replace element if damaged, dirty, or oily.

oil

aircleaner3 11/04 − 803 070 / S-0759

8-4. Overload Protection (Robin-Powered Units)

2	1	. Fuse F6	located	in
		harness	behind	left
		side door.

3

.Fuses F1, F2 located on

bracket behind left side panel.

! Stop engine. Disconnect negative (−) battery cable.

1 Fuse F1 (See Section 11-1)

F1 protects the weld excitation winding from overload. If F1 opens, weld output stops or is low.

2 Fuse F2 (See Section 11-1)

F2 protects the generator power excitation winding from overload. If F2 opens, generator power output stops or is low.

3 Fuse F6 (See Section 11-1)

F6 protects the engine wiring sys- tem from overload. If F6 opens, engine will not crank.

Replace any open fuses. Reinstall cover before operating.

.If a fuse opens, it usually indi-

cates a more serious problem exists. Contact a Factory Au- thorized Service Agent.

Tools Needed:

3/8 in

803 753-B

OM-4419 Page 33