Miller Electric 3000-4AH manual Installing Optional Tool Box, Installing Wiring Harness Connectors

Page 10

1 3

4

5

2

 

Tools Needed:

Use tab connector only with insulated wires.

 

1Connector

2Run Wire

3Tap Wire

Place unstripped run wire in slotted channel.

Insert unstripped tap wire into other channel until it hits internal stop.

4Contact

59 Inch Linemans Pliers

Use pliers to push contact down flush with top of connector.

Close top cover.

Ref. S-0448

Figure 3-3. Installing Wiring Harness Connectors

3-3. Installing Optional Tool Box

WARNING

TILTING OF TRAILER can result in personal injury or equipment damage.

Use adequate blocks or lifting device to support hitch end while pivoting trailer jack into position (see Section 3-1).

Use trailer jack to obtain desired height and to support tongue weight while installing tool box.

rwarn1.1* 3/93

2

13

4

Tools Needed:

9/16 in

Support trailer with jack. Apply parking brake.

1 Bracket

Attach brackets to frame using 3/8-16 x 1 hardware. Tighten hard- ware to 31 ft lb (40 N.m).

2Tool Box

3Mounting Tab

Place box on brackets and align mounting tabs on box with those on brackets.

4 Hook Bolt

Slide bolt through each mounting tab on bracket and up through mounting tab on tool box. Be sure “L” of bolts follows angle of mount- ing brackets.

Install 5/16 in flat washer, lock washer, and hex nut on hook bolt. Tighten to 31 ft lb (40 N.m).

5/8, 9/16 in

ST-800 014

Figure 3-4. Installing Tool Box

OM-659 Page 4

Image 10
Contents OM-659 DescriptionFrom Miller to You Trailer Towing can be hazardous Trailer Towing Safety PrecautionsOverloading can cause serious injury or equipment damage Unexpected Tilting of Trailer can cause injury and damage Incorrectly Working Lights can cause accidentsTable of Contents Page Specifications Safety InformationTrailer Installation & Operation Operating Parking Brake And JackInstalling Fenders And Lights Installing Fenders And LightsInstalling Optional Tool Box Installing Wiring Harness ConnectorsTilting of Trailer can result Health or killPersonal injury or equipment damage Installing Hitch And Connecting To Towing Vehicle Installing Welding Generator Installing Welding GeneratorMaintenance Block wheels when adjusting parking brakeTorquing Wheel Bearings Falling Equipment can causeParts List Complete AssemblyPart Description Quantity Optional Service SupportOwner’s Record Miller Electric Mfg. Co