WARNING |
CYLINDERS can explode if damaged. | BUILDUP OF SHIELDING GAS can harm | |||
• | Keep cylinders away from welding and other | health or kill. |
| |
• | electrical circuits. | • | Shut off shielding gas supply when not in use. | |
Never touch cylinder with welding electrode. |
|
|
| |
• | Always secure cylinder to running gear, wall, or |
|
|
|
| other stationary support. | TILTING OF TRAILER can result in | ||
|
| |||
|
| personal injury or equipment damage. | ||
|
| • | Use adequate blocks or lifting device to support | |
|
|
| hitch end while pivoting trailer jack into position (see | |
|
| • | Section |
|
|
| Use trailer jack to obtain desired height and to | ||
|
|
| support tongue weight while installing cylinder rack | |
|
|
| and cylinders. | warn4.1 9/91 / rwarn1.1* 3/93 |
| Support trailer with jack. Apply | |
| parking brake. | |
Shielding Gas Cylinder | 1 | Cylinder Rack |
| Install rack on frame as shown. Se- | |
| cure rack with | |
Adjust latch tension | hardware. Tighten hardware to 75 ft | |
so cylinder is | lb (100 N.m). | |
secure. | Install shielding gas cylinder as | |
| ||
| follows: | |
| 2 | Clamp |
| Pull back clamp to release. Install | |
End View – Latch Open | cylinder in rack. | |
End View – Latch Closed |
| |
| Adjust clamp by turning clamp | |
| clockwise to tighten or counter- | |
| clockwise to loosen. | |
| Close clamp to secure cylinder. If | |
| necessary, readjust clamp so cylin- | |
2 | der is secure. | |
1 |
|
|
Tools Needed:
3/4 in
13/16 in