(Replaces Aligning Fence on Page 31)
To ensure cutting accuracy when the fence is first installed, the fence should be aligned with the
miter slot.
To align the fence parallel with the miter slot:
1.DISCONNECT BANDSAW FROM POWER!
2.Make sure the miter slot is aligned with the bandsaw blade (refer to Aligning Table on G0513X Manual Page 30).
3.If the fence is mounted on the
4.Loosen the knobs and cap screw that secure the fence rail to the table (see Figure 3 on Page 10).
5.Adjust the fence face parallel with the edge of the miter slot, as shown in Figure 10.
NOTICE
Adjusting the fence parallel to the miter slot does not guarantee straight cuts. The miter slot may need to be adjusted parallel to the side of the blade. Refer to the "Aligning Table" instructions on G0513X Manual Page 30.
Disabling & Locking
Switch
I]ZedlZghl^iX]XVcWZY^hVWaZYVcYadX`ZYWn gZbdk^c\ i]Z `Zn! Vh h]dlc# AdX`^c\ i]Z hl^iX] ^c i]^h bVccZg XVc egZkZci jcVji]dg^oZY deZgV" i^dcd[i]ZbVX]^cZ!l]^X]^hZheZX^Vaan^bedgiVci ^[ i]Z bVX]^cZ ^h cdi hidgZY ^ch^YZ Vc VXXZhh" gZhig^XiZYWj^aY^c\#
IMPORTANT: AdX`^c\ i]Z edlZg hl^iX] l^i] V `ZndcangZhig^Xih^ih[jcXi^dc#>i^hcdiVhjWhi^ijiZ [dg Y^hXdccZXi^c\ edlZg [gdb i]Z bVX]^cZ l]Zc VY_jhi^c\dghZgk^X^c\#
0POWER I
Figure 10. Example of fence square with miter
slot.
6.Tighten the knobs and cap screw that secure the rail to the table, being careful not to move the fence.
Children or untrained people can be killed or seriously injured by this machine. This risk increases with unsupervised operation. To help prevent unsupervised operation, remove the key from the switch before leaving machine unattended! Place key in a
Model G0513X2B (Mfg. Since 5/11) |