5.Note that there are two different LED assemblies. One for the driver side and one for the passenger side. Select the correct assembly for the tail light housing. Remove the two locking nuts and flat aluminum plate from the back of the new LED assembly.
Left or driver’s | Right or passenger’s |
side LED assembly. | side LED assembly. |
6.Insert each new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation.
7.Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing. The flat side of the mounting disk should be toward the outside and the side with the slight raised center should go in toward the housing. This will index the mount in the original housing.
8.Secure the LED assembly into the housing with the supplied plate and nuts.