Evo Fitness 51551 owner manual Assembly instructions

ASSEMBLY

Step 8:

Cap Rear Upright (8) with 2" x 3" Rect End Plug (55). Insert Guide Rod (9) into the sleeve on Rear Upright (8) by placing Rear Upright (8) top-down. Attach Rear Upright (8) to Triangular Link Plates (27) using two 1/2" x 4- 1/4" Hex Head Bolts (73), four 1/2" x 1-1/16" Washers (89) and two 1/2" Nylon Nuts (94).

Attach each Rear Upright (8) to Rack (5) and Top Connect Beam

(4) using 1/2" x 4" Hex Head Bolt (74), two 1/2" x 1-1/16" Washers (89) and 1/2" Nylon Nut (94).

Attach 1" "C" Pin (93) to Weight Holder (33). Insert Weight Holders (33) into the holes in Rear Upright (8).

NOTE: The threaded end of Weight Holder (33) MUST face inner side.

Then tighten with 3/8" x 1-1/4"

Washer (88) and 3/8" x 3/4" Hex

Head Bolt (82).

Slide 3" Rubber Doughnut (61) and Short Olympic Sleeve (35) onto Weight Holder (33) and secure with 5/16" x 1/2" Set Screw (86). Secure Guide Rods (9) with 5/16" x 3/8" Set Screws (85).

assembly instructions

-15-