Grizzly H8150, H8149, H8148 owner manual Test Run, To test run the machine

Figure 10. Left tool rest and eye shield

assembly.

2.Assemble the right tool rest and eye shield in the same manner.

Test Run

Once your machine is mounted and assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 23.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure the switch is in the OFF position.

2.Connect the grinder to the power source.

-16-

3.Make sure you have read the safety instruc- tions at the beginning of the manual and that the grinder is is setup properly.

4.Make sure all tools and objects used during set up are cleared away from the grinder.

5.Flip the switch up to turn the grinder ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine OFF.

6.Listen to and watch for abnormal noises or actions. Under normal conditions, the grinder will make a humming noise, with only minor vibration.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power before investigating or correcting potential problems.

7.Turn the grinder OFF.

8.On Model H8148 and H8149 remove the safety key (Figure 11) and attempt to turn the machine ON.

—If the grinder does not start, the switch dis- abling feature is working.

—If the grinder starts, stop it. The switch dis- abling feature is not working. This safety feature must work properly before pro- ceeding. Call Tech Support for help.

Figure 11. Disabling switch.

H8148/H8149/H8150 Heavy Duty Bench Ginders