Installation

SITESELECTION

Select a solid, level surface to install the E-222 chopper. This area should be well lit and large enough to allow easy access to all sides of the machine.

ELECTRICAL

Your E-222 chopper is manufactured with a 20-amp power cord and plug. Contact a licensed elec- trician to install a 20-amp outlet. Do not try to modify a standard outlet to accommodate this plug. Failure to use a correct outlet will void the warranty. Also, check that the line voltage matches the motor specifications as shown on the serial plate.

APPROVEDUSES

The Berkel E-222 chopper is suitable to cut and chop the following products:

•Meat

•Poultry

•Fish

NON-APPROVEDUSES:

The Berkel E-222 chopper is not designed to cut and chop the following products:

•Non-food products

•Dry products

•Meat with bones

TESTINGPRIORTOOPERATION

1.Make sure the chopper is unplugged and is on a solid, level surface.

2.Check that the line voltage at the outlet matches the machine specifications.

3.Choose a knife and plate to install. (If you have just removed the chopper from its shipping carton, it is greased and ready to run with a 1/8” plate from the factory.) The standard plate has 1/8” (3.2mm) holes. Optional plates are 3/16” (4.8mm), ¼” (6.3mm), and 3/8” (9.5mm). It is recommended that a plate and knife should be matched and kept as a pair. They will wear evenly and provide the best operation of the chopper.

CAUTION

Mixing knives and plates will cause them to wear unevenly and possibly damage each other.

E-222 OWNER/OPERATOR MANUAL • 5