7.Click Finish, then click Yes to restart Windows to complete the driver installation.
For Existing Windows ME Installation
1.Install the board and boot up Windows ME.
2.At the Add New Hardware Wizard, insert the driver CD.
3.Select Automatic search for a better driver (Recommended), then click Next.
4.Accept the selected driver, then click OK.
5.Click Finish, then restart Windows to complete the driver installation.
Verify Proper Installation for Windows 98/ME
1.
2.Double click SCSI controllers and Silicon Image SiI 3114 ... Controller should be listed.
3.Highlight Silicon Image SiI 3114 ... Controller and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been correctly installed. If an error message is displayed, remove Silicon Image SiI 3114 ...
Controller and restart your system.
Windows NT4.0 Driver Installation
A new installation of Windows NT requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
For New Windows NT4.0 Installation
1.Install the board and follow Microsoft procedures to install Windows NT4.0 accordingly.
6
