Windows 2000 Driver Installation
A new installation of Windows 2000 requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
For New Windows 2000 Installation
1.Install the board and follow Microsoft procedures to install Windows 2000 accordingly.
2.Restart your system when prompted during Windows' installation.
3.At the Windows 2000 Setup screen, press F6 to install the driver.
4.Insert the driver diskette. Press S, then press Enter.
5.Select Silicon Image SiI 3114 ... Controller for Windows NT 4.0 and 2000, and press Enter.
6.Press Enter to continue and follow
For Existing Windows 2000 Installation
1.Install the board and boot up Windows 2000.
2.At the Found New Hardware Wizard, click Next.
3.Select Search for a suitable driver for my device (recommended) and click Next.
4.
Note: If a warning message pops up, click Continue Anyway, then click Finish. Our driver has been thoroughly tested in Windows for stability.
5.Click Finish, remove the driver CD and restart Windows to complete the driver installation.
8
