Enterasys Networks XSR-Series manual B1.0 show ip route, B1.1 show ip arp

Page 47

B1.0 show ip route

XSR-1805#show ip

route

 

 

 

Codes: C-connected, S-static, R-RIP, O-OSPF, IA-OSPF

interarea

 

N1

- OSPF

NSSA external type 1, N2 - OSPF NSSA external type 2

 

E1

- 0SPF

external type 1,

E2 - 0SPF external

type 2

 

* - candidate default, D -

default route originated from default net

C

192.168.224.0/24

[0001]

directly connected, FastEthernet2

* S

0.0.0.0/0

 

[0001]

via 192.168.224.1,

FastEthernet2

XSR-1805#

B1.1 show ip arp

XSR-1805#show ip arp

Protocol

Address Age(min)

Hardware Address Type Interface

Internet

192.168.224.11

-

00a0.c9c8.004f

ARPA

FastEthernet2

Internet

192.168.224.132

-

0001.f425.c2b2

ARPA

FastEthernet2

XSR-1805#

B1. show ip interface

XSR-1805#show ip interface

FastEthernet1 is Admin Up

Internet address is 10.10.10.1, subnet mask is 255.255.255.0 Rcvd: 0 octets, 0 unicast packets,

0 discards, 0 errors, 0 unknown protocol. Sent: 0 octets, 0 unicast packets,

0 discards, 0 errors. MTU is 1500 bytes.

Proxy ARP is disabled.

Helper address is not set.

Directed broadcast is enabled.

Outgoing access list is not set.

Inbound access list is not set.

Router discovery is disabled.

FastEthernet2 is Admin Up

Internet address is 192.168.224.132, subnet mask is 255.255.255.0 Rcvd: 8932656 octets, 5900 unicast packets,

0 discards, 0 errors, 5472 unknown protocol. Sent: 177264 octets, 3272 unicast packets,

0 discards, 0 errors. MTU is 1500 bytes.

Proxy ARP is enabled.

Helper address is not set.

Directed broadcast is enabled.

Outgoing access list is not set.

Inbound access list is not set.

Router discovery is disabled.

XSR-1805#

Configuration Guide

Page 47 of 55

Image 47
Contents Configuration Guide Table of Contents Appendix Helpful commands for using the XSR platformIP-Static-routing IP-Loopback Interface IP-Address and Secondary Addresses configurationIP-OSPF-routing IP-RIPv1,v2-routing Ip local pool 10th 10.10.10.0 Sntp Simple Network Time Protocol Duplex half System login bannerDuplex full Configuration Guide XSR-1805config#access-list 110 move 1 Access control list moving online editingHostname XSR-18051 Router-2-BackupVirtual Router Redundancy Protocol RFC Router-1-MasterVrrp 1 priority Vrrp 1 master-respond-ping no shutdown Vrrp monitor interface function, interface trackingIp address 10.10.10.1 255.255.255.0 no shutdown Access-list 10 permit 10.10.10.0NAT static bindings NAT dynamic with PAT Port Address TranslationDialer Interface Controller e1 0/2/0 clock source internal no shutdown Dialer Backup interface functionUsername remote privilege 0 password is not displayed PAP for authentication PPPInterface Dialer0 dialer pool Chap for authentication PPPUsername remote privilege 0 cleartext iamRemote Dialer-list 1 protocol ip list XSR-1805-1config#aaa user XSR-1805-1config-aaa#password XSRVPN via Dialer Interface rtr1 VPN via Dialer Interface rtr2 Dialer Int. PRI to BRI with D-channel-callbackcentral-site Ppp pap sent-username central password xsr ppp multilinkDialer Int. PRI to BRI with D-channel-callbackremote1-site Ppp pap sent-username remote1 password xsr1 ppp multilinkDialer Int. PRI to BRI with D-channel-callbackremote2-site Ppp pap sent-username remote2 password xsr2 ppp multilinkIsdn config for BRIx/x Isdn switch type changing Dialer-group Isdn callbackDialer caller 112233 callback dialer remote-name XSR-Remote Isdn multilink / Isnd channel bundling PPPoE on Adsl interface with chap authentication AAA Authentication Authorization Accounting Radius Logging Snmp Medium Ip ssh server disable Ip telnet server disableSSH / Telnet Syslog function, Server local-bufferSnmp v1/v2/v3 Snmp configuration /contact/location/parameterIp route 80.80.80.0 255.255.255.0 XSR-18051config#aaa user XSR-18051config-aaa#password XSR0r1 VPN Ipsec site-to-site tunnel via pre-shared key Router-1Ip route 10.10.10.0 255.255.255.0 XSR-18052config#aaa user XSR-18052config-aaa#password XSR0r2 VPN Ipsec site-to-site tunnel via pre-shared key Router-2VPN Ipsec site-to-site tunnel certification PKI Request certificate from CA y/n ? y XSR-18051config#crypto ca identity Enterasys-Networks-CAPassword Re-enter password XSR-18051config#crypto ca crl request Enterasys-Networks-CAENTITY-ACTIVE Certification control / certificates / Crls / CA identityPptp encrypt mppe auto VPN Pptp User terminationXSR-18051config#aaa user XSR-18051config-aaa#password XSR XSR-18052config#aaa user XSR-18052config-aaa#password XSR Version 6.0.0.0, Built Sep 14 2003 5r1 GRE native site-to-site tunnel5r2 GRE native site-to-site tunnel Diffserv Dscp field addressing Description internalloopbackPrivate ip address 13.13.13.1 Firewall configurationDescription InteralnetworkPrivate ip address 10.10.10.1 Ip address 30.30.30.1 Vlan configuration 802.1q tagged routingIp address 20.20.20.1 XSR-1805 uptime is 0 days, 2 hours, 23 minutes A1.2 ping & tracerouteVersion 2.02, Built Feb 24 2003 Version 4.0.0.0, Built Mar 26 2003Current operational speed is negotiated to 100 Mb/s Current operational duplex mode is negotiated to fullA1.4 telnet to other routers Physical link is currently upA1.6 verify the flash file checksum A1.5 flash/ cflash/ dir, rename, copy commandsB1.1 show ip arp B1.0 show ip routeC1.3 show crypto map C1.0 show tunnelsC1.1 show crypto isakmp sa C1.2 show crypto ipsec saC1.7 show ip route / GRE via Ipsec C1.4 show tunnels / GRE via IpsecC1.5 show interface vpn / GRE via Ipsec C1.6 show crypto ipsec sa / GRE via IpsecMTU is 1492 bytes D1.1 show ip interface atm 1/0.1D1.2 show controllers atm 1/0 VPI/VCI 1/32 D1.3 show controllers atm 1/0.1IfLastChange 001609 ATM 1/0 is Admin Up / Oper UpAdministrative State is Enabled Operational State is UP D1.4 show interface atm 1/0PPPoE is Oper Up ATM 1/0.1 is Admin Up / Oper UpD1.5 show interface atm 1/0.1 State OpenedCurrent State ATM 1/0.1 PPP is Admin Up / Oper UpChap authentication success with D1.6 show ppp interface atm 1/0.1Getting Help