Sharp XL-BD601PH On-screenError Messages, Specifications, Amplifier, BD player, Speaker, E-43

On-screen Error Messages

The following messages appear on the TV screen in case of an error during operation.

Error message	Possible Error	Suggested Solution
Cannot play.	● The disc cannot be played back with this Unit.	● Check the disc, and load it correctly.
Incompatible disc.	● If you load a disc which cannot be played with this Unit (i.e. a scratched
	disc), or if you load a disc upside down, this message will appear, and
	the disc tray will automatically pop out.
	● Occurs if the loaded disc cannot be played because it is a non-	● Remove the disc.
	standard disc or scratched, etc.
Cannot operate.	● Occurs if an operation is incorrect.	—
This USB memory is not formatted properly. Please format the	● Occurs if there is a formatting error.	● Format the USB memory again.
memory in USB memory management.	● Occurs if the USB memory is not formatted with FAT 32/16.	● Format the USB memory with your PC.
The Connected USB Memory cannot be used. It should be compliant	● Occurs if USB memory not compliant with USB 2.0 High Speed	● Connect USB 2.0 High Speed (480Mbit/s) compliant USB memory.
with USB 2.0	(480Mbit/s) is used (i.e. USB 1.0/USB 1.1).

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

■General

Power source	AC 220 - 240 V ~ 50/60 Hz
Power consumption	Power on: 52 W
	Power stand-by: 0.5 W (*)
Dimensions	Width: 215 mm (8 - 1/2”)
	Height: 96 mm (3 - 4/5”)
	Depth: 335 mm (13 - 1/5”)
Weight	2.75 kg (6.06 lbs.)
Operating temperature	5°C to 35°C
Storage temperature	–20°C to 60°C
Operating humidity	10 % to 80 % (no condensation)
TV systems	PAL system/NTSC system (The system
	recorded on the disc is output.)

(* ) This power consumption value is obtained when the demonstration mode is cancelled in the power stand-by mode. Refer to page 10 to cancel the demonstration mode.

■Amplifier

Output terminals	Speakers: 6 ohms
	20Hz - 20kHz
	Subwoofer Pre-out (audio signal):
	200 mV/10 k ohms at 70 Hz
	Video output: 1 Vp-p
	Headphones: 16 - 50 ohms
	(recommended: 32 ohms)
	HDMI 19-pin standard connector (1080p
	24Hz output)
	HDMI™ (Deep Colour, x.v.Colour, Dolby
	TrueHD, DTS-HD Master Audio Essential)
Input terminals	Audio In (audio signal):
	500 mV/47 k ohms
	Line in (Analogue input):
	500 mV/47 k ohms
	Digital audio optical input terminal: Square
	Optical terminal
	Ethernet:
	10BASE-T/100BASE-TX
■ BD player
Type	Single disc multi-play disc unit
Signal readout	Non-contact, 3-beam
	semiconductor laser pickup
Playable discs/	BD-ROM, BD-RE, BD-R,
media formats	DVD Video, DVD+RW/+R/-RW/-R (Video/
	VR/AVCHD/JPEG file/MP3 file/DivX
	(H.264/MKV) format),

■ USB

USB	● USB 1 (5 V dc 500 mA
	USB 2.0 High Speed (for Local Storage/
	Software Update/JPEG/MP3 and DivX
	(H.264/MKV) playback)
	● USB 2 (5 V dc 2.1 A)
	(iPod/iPhone and iPad compatibility)
■ Tuner
Frequency range	FM: 87.5 - 108 MHz
Preset	40 (FM station)
■ Speaker
Type	2-way type speaker system
	2.5 cm (1”) Dome-Tweeter
	12 cm (4-3/4”) woofer
Maximum input	100 W
power
Rated input power	50 W
Impedance	6 ohms
Dimensions	Width: 148 mm (5-13/16”)
	Height: 262 mm (10-5/16”)

Output power

PMPO: 200 W

MPO: 100 W (50 W + 50 W) (10% T.H.D.)

RMS: 100 W (50 W + 50 W) (10% T.H.D.)

RMS: 66 W (33 W + 33 W) (1% T.H.D.)

	Audio CD (CD-DA), CD-RW/R (CD-DA/
	JPEG file/MP3 file format)
Region code	B or marked ALL for BD, 2 or marked ALL
	for DVD
D/A converter	Multi bit D/A converter
Frequency response	20 - 20,000 Hz
Dynamic range	90 dB (1 kHz)

	Depth: 203.5 mm (8”)
Weight	2.50 kg (5.51 lbs.)/each

E-43