Settings (continued)
7� Enter the
Enter
8� Press ENTER to start checking data in the USB memory device.
Insert USB memory device containing the software update file.
OK
Software update file is not detected in the USB memory device. Confirm that you have transferred the file
to the USB memory device and retry software update. Confirm that you have inserted the USB memory device into the correct device.
OK
There is more than one software file in the USB memory device.
Confirm that only the software update file is in the USB memory device.
OK
Caution:
●Do not remove the USB memory device or unplug the AC power lead while the software is being updated.
When you insert or remove a USB memory device, be sure to turn the main power off and make sure that “Quick Start” is set to “No” (See page 28).
� Insert the USB memory device with the update file into the USB1 terminal on this unit.
Note:
●A USB memory device can be used only with USB1 terminal.
Rear
USB memory device
2� Press
3� Press / to select “Settings”, then press or ENTER.
4� Press / to select “Software Update Settings”, then press
or ENTER.
5� Press / to select “Manual Update”, then press or ENTER. 6� Press / to select “USB Memory”, then press ENTER.
●If you have set the PIN code, go to step 7, otherwise go to step 8.
9� During the data checking, “Checking” blinks.
Now checking the data in USB memory device.
Checking
●The current version of this unit software and the version of the update file on the USB memory device are displayed. To update this unit software with update file, select “Yes”, and press ENTER.
Software update file is detected in the USB memory device.
Start update?
Current Ver. : | xxxxxxxxxx | |
Update Ver. : | yyyyyyyyyy | |
|
|
|
| Yes |
|
|
|
|
| No |
|
●If the USB memory device is not properly installed or the correct update file cannot be found on the USB memory device, an error message is displayed.
Check the file on the USB memory device, and then reinsert the USB memory device correctly.
0�Press ENTER to start updating.
●The screen becomes dark for a while until the update screen can be displayed. Please wait for the update screen to appear. Do not unplug the AC power lead.
The picture will temporarily go dark until the software update display appears.
Wait several minutes and do not unplug the AC cord.
OK
Now updating
*Do not unplug AC cord.
Update Version | yyyyyyyyyy |
30%
�When the software is successfully updated, a screen is displayed indicating that the update process is completed.
●If the update has failed, check the file in the USB device and try Software Update again.
2�Press
●Delete unneeded software update data using a PC after the software update process is completed.
3�Remove the USB memory device.