Craftsman 320.2819 operating instructions To Adjust Depth Figs 6 and 6a

To Adjust Depth (Figs° 6 and 6a)

. Turn router motor off and unplug from power source_

2_ Place router on a flat, level surface with back of fixed base facing you, Open Router Motor Clamp (A),

3_	With the cutting bit in-
	stalled: press in the Coarse
	Adjustment		Knob (B),
	lower the router motor in
	the base until the cutting
	bit is very close to the
	surface on which the base
	is sitting, and turn the Fine
	Adjustment		Dial	(F) until	the
	cutting	bit	"just"	touches	Fig. 6a	.........
	the flat surface on which
	the base is sitting,, Then
	lock the	Router		Motor
	Clamp	(A),

4_ While continuing to press the

Coarse Adjustment Knob (B), turn the Fine Adjustment Dia! (F) until ZERO "0" mark on Depth Indicator Ring (E) is lined up with the "1" mark on base.

5.Release the Coarse Ad-

justment Knob, making sure the "0" stays lined up with the mark,

6_ Place the router on two level scrap work pieces, positioned so the cutting bit can be lowered below the sub-baseo

7.Turn the Fine Adjustment Dial (F) counterclockwiseito lower the bit to the desired depth of cut° Turn the dial clockwise to raise the cutting bit,

8.Once your depth of cut is set, close the router motor clamp (A) securely.

NOTE: Making a single deep cut is never advisable'_ Smaller diameter cutting bits are easily broken by too much side thrust and torque. Larger cutting bits will cause a rough cut and be difficult to guide and control. For these reasons, DO NOT EXCEED 1/8 in. DEPTH OFICUT in a single pass.

28190 Manual_Revised_07_0409 Page 20