Cisco Systems OL-1911-05 manual Card /subcard /port .subinterface# multipoint, Elan-name, 24-11

Chapter 24 Configuring ATM Router Module Interfaces

Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR)

Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR)

Note

Note

Note

The procedures for configuring LANE clients (LECs) on the ATM router module are the same as for the configuration of LECs on the route processor, with one exception: To specify an ATM router module interface, rather than the route processor interface, use the interface atm card/subcard/port command. On the route processor, you would use the interface atm 0 command.

To route traffic between an emulated LAN and a Fast Ethernet (FE) or Gigabit Ethernet (GE) interface, you must configure the LEC on an ATM router module interface rather than a route processor interface.

An ATM router module interface can be configured for either LECs or RFC 1483 PVCs, not both. For both features to operate on the same ATM router module, configure LECs on one interface and RFC 1483 PVCs on the other.

LANE clients are not supported on the Catalyst 8540 MSR enhanced ATM router module.

To configure a LEC on an ATM router module interface, use the following commands, beginning in global configuration mode:

	Command	Purpose
Step 1
	Switch(config)# interface atm	Creates the ATM router module
	card/subcard/port.subinterface# multipoint	point-to-multipoint subinterface and enters
	Switch(config-subif)#	subinterface mode.
		Note The ATM router module only supports
		point-to-multipoint subinterfaces.
Step 2
	Switch(config-subif)# ip address ip-address mask	Provides a protocol address and subnet mask for
		the client on this subinterface.
Step 3
	Switch(config-subif)# lane client ethernet	Enables a LANE client for an emulated LAN.
	elan-name

	ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05		24-11