Chapter 24 Configuring ATM Router Module Interfaces
Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR)
Router 1 ATM Interface
Router1# configure terminal
Router1(config)# interface atm 2/0
Router1#
ATM Switch Router ATM Router Module Interface
Switch# configure terminal
Switch(config)# interface atm 2/0/0
Switch#
Router 2 ATM Interface
Router2# configure terminal
Router2(config)# interface atm 3/0
Router2(config-if)# ip address 1.0.0.3 255.0.0.0
Router2#
For detailed information on configuring LANE clients (LECs), see Chapter 13, “Configuring
LAN Emulation.”
LANE Routing from ATM to Ethernet
The following example shows how to configure LANE routing from ATM to Ethernet using the ATM router module. Figure
Figure 24-4 Example Network for LANE Routing from ATM to Ethernet
Router 1 | Catalyst 8540 MSR | ||
|
| ||
|
|
|
|
| ATM 2/0 |
| GE 9/0/0 |
|
| ATM router module | |
|
| Interface ATM 2/0/0 |
Router 2
GE 9/0/0
45222
|
| ATM and Layer 3 Switch Router Software Configuration Guide |
|
| ||
|
|
| ||||
|
|
|
|
| ||
|
|
|
|