Cisco Systems OL-1911-05 manual Displaying the Bridging Configuration, Show bridge verbose, 24-26

Chapter 24 Configuring ATM Router Module Interfaces

Configuring Bridging

Example

In the following example only PVC 2, 200 is used for packet flooding:

Switch(config)# interface atm 3/0/0

Switch(config-if)# no ip address

Switch(config-if)#no ip directed-broadcast

Switch(config-if)# map-group bg_1

Switch(config-if)#atm pvc 2 200 interface atm 1/0/1 0 200

Switch(config-if)#atm pvc 2 201 interface atm 1/0/1 0 300

Switch(config-if)# bridge-group 5

Switch(config-if)# end

Switch(config)# map-list bg_1

Switch(config-map-list)#bridge atm-vc 200 broadcast

Note For more information about bridging, refer to the Layer 3 Software Configuration Guide.

Displaying the Bridging Configuration

To display the bridging configuration on the ATM router module interface, use the following privileged EXEC command:

Command					Purpose
show bridge verbose					Displays the entries in the bridge forwarding
					database.
Example
Switch# show bridge verbose
Total of 300 station blocks, 297 free
Codes: P - permanent, S - self
BG Hash		Address	Action	Interface		VC	Age RX count TX count
5	28/0	0000.0ce4.341c forward		Fa0/0/0			-
5	2A/0	0000.0cac.be94 forward		ATM3/0/0			200
5	FA/0	0060.3e59.c63c forward		Fa0/0/0			-

	ATM and Layer 3 Switch Router Software Configuration Guide
24-26	OL-1911-05