Cisco Systems 828, 78 manual Connecting Hubs

Chapter 2 Installation

Installing Your Router

Connecting Hubs

Before connecting a hub, see Table 2-2. To connect one of these devices, follow the steps in Figure 2-1.

Figure 2-1 Connecting a Hub

1. Set TO HUB/TO PC button. Cisco 828 router

2.Connect yellow cable to ETHERNET 4 port on Cisco 828 or SOHO 78 router.

TO HUB	ETHERNET 10	BASE T	Model
TO PC				Cisco
			CONSOLE		828

			G.
4	3		SHDSL	+5 VDC
		2
			1

Cisco 1528 Micro Hub 10/100

					1X
SPEED					2X	ETHERNET 3X
	LED
100BaseTX		1
10BaseT	SOLID		2	3	4
		5	6
	BLINK			7	8
					6X
						7X

3.Connect other end of cable to hub.

4X
8X			56634
	MDI	MDI-X

4.If applicable, check setting of hub equivalent of router TO HUB/TO PC button.

To verify your hub connection, ensure that the appropriate Ethernet LED on the front panel is on after you have completed the router installation. For example, if you have connected the cable to Ethernet port 3, ensure that the ETHERNET 3 LED on the front panel is on.

If the LED is not on, see Table 3-2 in Chapter 3 for troubleshooting information.

	Cisco 828 Router and SOHO 78 Router Hardware Installation Guide
78-12837-02		2-7