Cisco Systems 828, 78 manual Connecting the G.SHDSL Line, Connecting an G.SHDSL Line to a Wall Jack

Page 33

Chapter 2 Installation

Installing Your Router

Connecting the G.SHDSL Line

The procedure for connecting the G.SHDSL line depends on the router and, in some cases, on your location. This section describes how to connect the G.SHDSL line to a cable wall jack.

Warning To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.

Figure 2-3 Connecting an G.SHDSL Line to a Wall Jack

Cisco 828 router

TO HUB TO PC

ETHERNET 10	BASE T

4	3
	3	2
		2	1
			1

Model
Cisco
CONSOLE	828

G.SHDSL

+5 VDC

56637

1.Connect lavender cable to G.SHDSL port.

2. Connect other end of cable to wall jack.

		Cisco 828 Router and SOHO 78 Router Hardware Installation Guide

	78-12837-02			2-9
	78-12837-02			2-9

Image 33

Contents Cisco 828 Router Soho 78 Router Hardware Installation Guide Page Copyright 2005 Cisco Systems, Inc. All rights reserved Page Features Definitions of Service Request SeverityOrganization Conventions Cisco.comInstallation Installing Your RouterVii Viii Organization AudienceConventions Preface Conventions Obtaining Documentation Related DocumentationCisco.com Documentation DVDOrdering Documentation Documentation FeedbackReporting Security Problems in Cisco Products Cisco Product Security OverviewPsirt Cisco Technical Support Website Obtaining Technical AssistanceSubmitting a Service Request Obtaining Additional Publications and Information Definitions of Service Request SeverityXviii Feature Routers Description FeaturesRouter Overview SohoDram Cisco 828 Router Front Panel Front PanelsBack Panels Ethernet ports Shdsl port Power switchColor Function LEDsEthernet TXD Ethernet RXDSafety Preparing for InstallationBefore installing the router, read the following warnings Preventing Electrostatic Discharge Damage Unpacking the Box Preventing Router DamageConnecting Ethernet Devices Installing Your RouterNetwork Router to Device Network Device Ethernet CableConnected to Router Router Port Type Button Setting Connecting Hubs Connecting a Server, PC, or Workstation Connecting an G.SHDSL Line to a Wall Jack Connecting the G.SHDSL LineConnecting the Power Supply Connecting a Terminal or PCConnecting the Power Supply Verifying the Router Installation Power/Link LEDs to Check Normal PatternsMounting the Router Wall-Mounting Brackets Bottom of Router Mounting the Router on a Wall Where to Go from Here Installation Where to Go from Here Before You Call Your Cisco Reseller TroubleshootingProblems During First Startup Symptom Problem SolutionsTo HUB/TO PC Troubleshooting Problems After Router Is Running System Specifications Description Design Specification Physical DimensionsEnvironmental Operating Ranges Description Design Specification Port Connector PinoutsRouter Power All national laws and regulationsTX+ RX+ Function To HUB/TO PC Button Pin Position OUT PositionPin Function RTS DTR TXD GND RXD DSR CTSCabling Specifications Ethernet Cable SpecificationsType Category Shielding Cable Maximum Distance Maximum Cable DistancesAppendix a Specifications and Cables Cabling Specifications Numerics GL-2 GL-3 GL-4 D E Shdsl Ethernet RXD LED Ethernet TXD LEDIN-3 IN-4