Cisco Systems 78, 828 manual Mounting the Router on a Wall

Page 38

Chapter 2 Installation

Mounting the Router

Figure 2-7 Mounting the Router on a Wall

1.Secure two screws 758 inches (19.35 cm) apart in a wall and 18 in. (0.32 cm) from

the wall.

				.35
	5	in	.	(19
			.

7	8

Wall

Wall-mount screw

cm)

Wall-mount screw

1 ETHERNET4 3 2

RXD

TXD

Front panel

OK

G	C
.	D
SHDSL
RXD
TXD

Mounting brackets

2. Hang router on screws.

18 in. (0.32 cm)

Wall

Screw

Maximum distance 6 ft (18 m)

3. Place power supply on horizontal surface.

Cisco 828 Router and SOHO 78 Router Hardware Installation Guide

2-14

56640

78-12837-02

Image 38

Contents Cisco 828 Router Soho 78 Router Hardware Installation Guide Page Copyright 2005 Cisco Systems, Inc. All rights reserved Page Organization Conventions Definitions of Service Request SeverityFeatures Cisco.comInstalling Your Router InstallationVii Viii Audience OrganizationConventions Preface Conventions Cisco.com Related DocumentationObtaining Documentation Documentation DVDDocumentation Feedback Ordering DocumentationPsirt Reporting Security Problems in Cisco ProductsCisco Product Security Overview Obtaining Technical Assistance Cisco Technical Support WebsiteSubmitting a Service Request Definitions of Service Request Severity Obtaining Additional Publications and InformationXviii Features Feature Routers DescriptionDram Router OverviewSoho Front Panels Cisco 828 Router Front PanelEthernet ports Shdsl port Power switch Back PanelsLEDs Color FunctionEthernet RXD Ethernet TXDPreparing for Installation SafetyBefore installing the router, read the following warnings Preventing Electrostatic Discharge Damage Preventing Router Damage Unpacking the BoxNetwork Installing Your RouterConnecting Ethernet Devices Router to Device Network Device Ethernet CableConnected to Router Router Port Type Button Setting Connecting Hubs Connecting a Server, PC, or Workstation Connecting the G.SHDSL Line Connecting an G.SHDSL Line to a Wall JackConnecting a Terminal or PC Connecting the Power SupplyConnecting the Power Supply Mounting the Router Verifying the Router InstallationPower/Link LEDs to Check Normal Patterns Wall-Mounting Brackets Bottom of Router Mounting the Router on a Wall Where to Go from Here Installation Where to Go from Here Troubleshooting Before You Call Your Cisco ResellerTo HUB/TO PC Problems During First StartupSymptom Problem Solutions Troubleshooting Problems After Router Is Running Environmental Operating Ranges System SpecificationsDescription Design Specification Physical Dimensions Router Power Port Connector PinoutsDescription Design Specification All national laws and regulationsPin Function Function To HUB/TO PC Button Pin Position OUT PositionTX+ RX+ RTS DTR TXD GND RXD DSR CTSType Category Shielding Cabling SpecificationsEthernet Cable Specifications Maximum Cable Distances Cable Maximum DistanceAppendix a Specifications and Cables Cabling Specifications Numerics GL-2 GL-3 GL-4 D E Ethernet RXD LED Ethernet TXD LED ShdslIN-3 IN-4