Cisco Systems 828, 78 manual Troubleshooting

Page 43

Chapter 3 Troubleshooting

		Problems During First Startup
Table 3-1 Problems During First Startup (continued)

Symptom	Problem	Solutions

No connection to	Wrong cable.	To make sure that you are using the correct cable, see
G.SHDSL link.		Appendix A.
(The CD LED on
the front panel is
off for a long
time.)

	Improperly connected	• To make sure that you have cabled the router
	cable.	properly, see Figure 2-3 in Chapter 2, “Installation.”
		• Make sure that the connectors at both ends of the
		cable are securely seated.

		Cisco 828 Router and SOHO 78 Router Hardware Installation Guide

	78-12837-02			3-3
	78-12837-02			3-3

Image 43

Contents Cisco 828 Router Soho 78 Router Hardware Installation Guide Page Copyright 2005 Cisco Systems, Inc. All rights reserved Page Cisco.com Definitions of Service Request SeverityFeatures Organization ConventionsInstallation Installing Your RouterVii Viii Organization AudienceConventions Preface Conventions Documentation DVD Related DocumentationObtaining Documentation Cisco.comOrdering Documentation Documentation FeedbackCisco Product Security Overview Reporting Security Problems in Cisco ProductsPsirt Cisco Technical Support Website Obtaining Technical AssistanceSubmitting a Service Request Obtaining Additional Publications and Information Definitions of Service Request SeverityXviii Feature Routers Description FeaturesSoho Router OverviewDram Cisco 828 Router Front Panel Front PanelsBack Panels Ethernet ports Shdsl port Power switchColor Function LEDsEthernet TXD Ethernet RXDSafety Preparing for InstallationBefore installing the router, read the following warnings Preventing Electrostatic Discharge Damage Unpacking the Box Preventing Router DamageRouter to Device Network Device Ethernet Cable Installing Your RouterConnecting Ethernet Devices NetworkConnected to Router Router Port Type Button Setting Connecting Hubs Connecting a Server, PC, or Workstation Connecting an G.SHDSL Line to a Wall Jack Connecting the G.SHDSL LineConnecting the Power Supply Connecting a Terminal or PCConnecting the Power Supply Power/Link LEDs to Check Normal Patterns Verifying the Router InstallationMounting the Router Wall-Mounting Brackets Bottom of Router Mounting the Router on a Wall Where to Go from Here Installation Where to Go from Here Before You Call Your Cisco Reseller TroubleshootingSymptom Problem Solutions Problems During First StartupTo HUB/TO PC Troubleshooting Problems After Router Is Running Description Design Specification Physical Dimensions System SpecificationsEnvironmental Operating Ranges All national laws and regulations Port Connector PinoutsDescription Design Specification Router PowerRTS DTR TXD GND RXD DSR CTS Function To HUB/TO PC Button Pin Position OUT PositionTX+ RX+ Pin FunctionEthernet Cable Specifications Cabling SpecificationsType Category Shielding Cable Maximum Distance Maximum Cable DistancesAppendix a Specifications and Cables Cabling Specifications Numerics GL-2 GL-3 GL-4 D E Shdsl Ethernet RXD LED Ethernet TXD LEDIN-3 IN-4