Attaching the Legs to the Table TOP

. Place the router tableFig, 2 surface upside down on

a flat, level surface, with the underside of the table

facing up.

,Position the legs relative to the router table as shown

in Fig, 2.

3_ Position one short end of the table so that it extends beyond the edge of your work surface far enough

to gain access to the four holes in that end of the

router-table top.

,Align the two outermost holes on the table top with the holes in the leg bracket.

.	Place a flat washer (12) onto
	each of two short, pan-head
	screws (8),Insert the short,
	pan-head screws up through
	the holes in the table and
	through the holes in the leg
	brackeL Place a small washer
	(12). a spring washer (13), and
	small nut (10) on the threads
	of the screw. Loosely tighten
	the nuts. (Fig. 2)

,Place a flat washer (12) onto each of two long, pan-head screws (7). Insert the long, pan-head screws up through the other two holes on the table top

and through the corresponding holes in the leg. Place a small washer (12), a spring washer (13). and small nut (10) on the threads of the screw. (Fig. 3)

7.Securely tighten all fasteners.

8.Repeat with the other leg,

28180 ManuaLRevisad_074:)228

Page 14