Craftsman 320. 28180 operating instructions General Maintenance, Problem, Cause

Page 22

GENERAL MAINTENANCE

,_ WARNING" Avoid using solvents when cleaning plastic parts. Most plastics

are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

,_ WARNING; Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic, which may result in serious personal injury.

WARNING" Always wear safety goggles or safety glasses with side shields

during power-tool operation or when blowing dust. If the operation is dusty, also wear a dust mask.

PROBLEM

The router does not work

The table surface is not flat

The router can not

be attached to the table

CAUSE

The router is not plugged into the table outlet.

The router-table cord is

not connected to a power source

The Router switch is in "OFF" position,

Legs are not properly as- sembled,

Work surface is not flat.

Sub-base is too large

SOLUTION

Insert router power cord plug into a table outlet

Plug the router-table cord into a power source

Insert key and pull the switch to the ON position

Check assembly directions and securely tighten all fasteners

Place router table on a flat, level surface

Use a sub-base 6-7/8 in. in diameter or less.

28:$80 Manual_Revlsed_07-O228

Page 22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents
Router Table ONE Year Full Warranty on Craftsman Tool Read ALL InstructionsiSymbol Meanings Damage Prevention and Information MessagesFrequency cycles per second Power Work Area Safety Grounded toolsDouble-insulated tools Minumum Gauge for Extension Cords Personal SafetyAWG Wearyour Tool USE and Care SafetyKeep your hair, clothing, and gloves away from moving parts Service Safety Specific Safety for the Router TableManualRevlsed07-022S Page10 This Router Table has the following features ManualRevised07-0228 Page12 Description QuantityAttaching the Legs to the Table TOP Attaching the Router Fig To the TableAttaching the Fence to the Table Fig Mounting the Table to a Work Surface See FigSwitch Operation To operate the switchDust Shield 28/80 ManuatRevised07-0228 Page/8 To laterally adjust the infeed and ouffeed fence Adjusting the FenceTo adjust the extended fence forward and backward Fig To adjust the outfeed fence for joining FigAdjusting Cutting Height Using the Router with the Router Table Routing OperationProblem General MaintenanceCause 28180ManualRevlsed07-0228Page23 Get it fixed, at your home or ours
Related manuals
Manual 24 pages 52.95 Kb