Craftsman 320. 28180 operating instructions Attaching the Router Fig, To the Table

Page 15

ATTACHING THE ROUTER Fig. 4

TO THE TABLE

Attach the router to the router table after you have assem- bled the table.

2_

.

Place the router table upright, with the front edge closest to you.

Be sure that the table is stable and that it rests on all four legs,

Remove the sub-base from the fixed-based router supplied.

4_ Hold the router upside down, and align the three holes in the center of the table with the holes in the router, as shown in Fig° 4. Position the router so that the screw holes used for attachment are not directly above either of the router handles.

5.Insert a flat-head screw through each of the three router-table holes into the router holes.

6_ Hold the router with one hand, and securely tighten each flat-head screw (9) with the other hand.

If you install a different router (one not supplied to the table), ensure that the di- ameter of the router sub-base does not exceed 6-7/8 inches. Six mounting holes for the router are distributed in

the center

of the table; the

dis-

Fig, 5

tance

between

two

opposite

6 71e"

holes is 5-3/8"o Select three

 

appropriate holes to mount the

 

router to the table. (Fig, 5)

 

 

The adjusting hole in the

 

 

table, shown in Fig. 5, is for

 

cutting

height

adjustment

of

 

the router

supplied

(Model

 

 

No. 17541) or the following

 

 

Craftsman

reuters:

17542

and

 

17543.

 

 

 

 

 

 

 

 

 

 

 

 

Adjusting Hole

28180 ManuaLRevlsed_07-0228

Page 15

Image 15
Contents Router Table Read ALL Instructionsi ONE Year Full Warranty on Craftsman ToolDamage Prevention and Information Messages Symbol MeaningsFrequency cycles per second Power Grounded tools Work Area SafetyDouble-insulated tools Personal Safety Minumum Gauge for Extension CordsAWG Tool USE and Care Safety WearyourKeep your hair, clothing, and gloves away from moving parts Specific Safety for the Router Table Service SafetyManualRevlsed07-022S Page10 This Router Table has the following features ManualRevised07-0228 Page12 Quantity DescriptionAttaching the Legs to the Table TOP To the Table Attaching the Router FigMounting the Table to a Work Surface See Fig Attaching the Fence to the Table FigTo operate the switch Switch OperationDust Shield 28/80 ManuatRevised07-0228 Page/8 To adjust the outfeed fence for joining Fig Adjusting the FenceTo adjust the extended fence forward and backward Fig To laterally adjust the infeed and ouffeed fenceAdjusting Cutting Height Routing Operation Using the Router with the Router TableGeneral Maintenance ProblemCause 28180ManualRevlsed07-0228Page23 Get it fixed, at your home or ours