Digimerge D4202 user manual Sensor

STEP 8: DVR REMOTE SETTING

1.Connect the DVR and monitor.

2.In the “Remote” setting, set the baud rate and ID the same as the “Peripheral” setting on the video web server. Set the remote mode to RS-485.(see example below)

A. 1 / 4 CH DVR

B. 4 / 9 / 16 CH DMR

(MENU)

TIMER

CAMERA RECORD ALARM DWELL REMOTE SYSTEM EVENT

(MENU)

SEARCH

TIMER

RECORD CAMERA SYSTEM EVENT

(REMOTE)

REMOTE MODE : RS-485

BAUD RATE : 2400

ID : 001

(SYSTEM)

:

:

REMOTE MODE : RS-485

BAUD RATE : 2400

REMOTE ID : 001

STEP 9: PIN CONFIGURATIONS

After the remote setting, connect the DVR, noting the following pins below

Pin 5

GND

N.O. Sensor

ALARM INPUT

Pin 4,7, 8 or 9

A normally open contact/sensor can be connected where

Pin 5 is Ground and Pin 4, 7, 8 and 9 is the Alarm Input

PIN 1, 6. RS485-A, RS485-B

Use the RS485-A & RS485-B serial communication signals to control digital units, such as a DVR.

PIN 4, 7, 8, 9. ALARM INPUT

Use the PIN 4,7,8,9 to receive the alarm input and trigger the Video Server to send mail to users for the a uto e-mail warning system. (Alarm1, 2 are for CH1; alarm3, 4 are for CH2)

-24-