Assembly
Tools required for assembly:
1 Flat head screwdriver
1Set of
1Set of Hex wrenches
1Adjustable wrench
Installing Drum Head
The drum sander must be bolted down to a workbench or stand. If you purchased one of the JET stands, place the sander base on the stand and align the holes. Secure the sander to the stand using four 3/8” x 3/4” hex cap screws and four 3/8” flat washers. See Figure 4.
Attach the handwheel (A, Figure 6) to the height adjustment screw, and tighten the two set screws with the 4mm hex wrench supplied.
Installing Conveyor Table
1.Raise the drum as far as it will go by turning the handwheel (A, Figure 5) clockwise.
2.Align the four holes in the conveyor with the four holes in the base of the drum assembly.
3.Secure the conveyor in place with four
4.Plug the motor cord into the control box receptacle.
IMPORTANT: The conveyor belt has been over- tensioned for the purpose of shipping. Before operating the sander, adjust the belt tension according to instructions on page 15.
Infeed and Outfeed Tables (Optional
Accessory)
1.Bolt the base bracket (B, Figure 6) to the sander base with two
(D). Tighten the screws.
2.Mount the table (A) to the base bracket (B) with four
3.Place a straight edge on the conveyor bed and extending out over the extension table. Raise or lower the extension table until it is level with, or slightly below, the surface of the conveyor belt. Tighten the hex nuts (G).
4.Repeat for the other table.
10
Figure 4
Figure 5
Figure 6