Beginning Assembly
This section will cover the basic assembly and adjustment instructions needed to begin opera- tion. Complete the assembly in the order provid- ed in this manual and then read the remaining portion of the manual before attempting any type of operation.
Your safety is important! Please follow the warnings below during this entire section:
Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
!could occur if you
power source before you have completed the assembly process. DO
NOT connect the machine to the power source until instructed to do so.
Sharp edges on metal parts may cause person- al injury. Examine the edges of all metal parts before handling.
Mounting Sander
To mount the sander to a workbench:
1.Screw 1⁄4" x 11⁄2" (or longer) lag bolts with 1⁄4" washers through the holes in the base and into the workbench.
To attach the sander to a mounting board:
1.Mount the base of the sander to the center of a piece of 3⁄4" plywood that is at least 18"W x 24"D.
2.Clamp the plywood securely to a workbench.
To install the disc guard:
1.Align the disc guard with the holes on the lower half of the disc.
2.Use the M4 x 8 self tapping screws to attach the disc guard to the sander base as shown in Figure 4.
Figure 4. Attaching the disc guard.
|
|
|
|
|
|
|
|
|
|
|
|
| G0547 Combo Sander | ||