Grizzly G0547 instruction manual Installing Disc Table, Squaring Table, To install the disc table

Page 15

Installing Disc Table

To install the disc table:

1.Lay the table upside down and align the table support with the holes in the table.

2.Take three hex bolts out of the hardware bag and put a lock washer and a flat washer on each bolt.

3.Screw the hex bolts with washers through the table support and into the disc table as shown in Figure 5.

Figure 5. Bolting the table support to the disc table.

4.Insert the index pin shown in Figure 6 into the upper hole on the base and tighten the knob.

Index Pin

Figure 6. Inserting the index pin into the base.

Squaring Table

When the table tilt is set to 0˚, the table should be adjusted perpendicular to the sanding disc face.

To square the table:

1.Disconnect the machine from the power source!

2. Using a try square or machinist’s square, set one edge on the table surface and the other against the face of the disc as shown in

Figure 7.

!

Figure 7. Squaring disc table.

3.Loosen the lock knob and adjust the table angle until there is no gap between the disc face and the square.

4.Tighten the lock knob while holding the table perpendicular.

5.Place the angle measurement label on the base so the angle indicator points to 0˚.

 

 

 

 

 

 

 

 

 

 

 

 

G0547 Combo Sander

-13-

Image 15
Contents Model G0547 Combo SanderPage Table of Contents Safety Instructions for Power Tools SafetyLength Grip the Workpiece with Both Hands Additional Safety Instructions for the G0547 Combo SanderIntroduction Volt Circuit RequirementsGrounding Extension Cords110V Operation Machine Features Description SET UPUnpacking Parts InventoryHardware Recognition Chart Weight Load Site ConsiderationsWorking Clearance To mount the sander to a workbench Beginning AssemblyTo install the disc guard Mounting SanderInstalling Disc Table To install the disc tableSquaring Table Attaching Sandpaper Aligning Table Adjusting Miter GaugeTo install the back stop Adjusting Belt AngleInstalling Back Stop Installing Sanding BeltTo connect your machine to a dust collection system Adjusting Sanding Belt TrackingInstalling Dust Collection Hose To test the trackingOperations General Power SwitchDisc Sanding Miter SandingTo perform miter sanding operations Angle Sanding Installing Table on Sanding BeltTo perform curved sanding operations Horizontal SandingCurved Sanding To perform horizontal sanding operationsMaintenance Maintenance SafetySchedule Lubricating Sleeve Bearings Replacing Drive BeltExtra A/O Belts Aftermarket AccessoriesReference Info GeneralMachine Data Sheet Parts Breakdown Description Trouble Cause Correction Troubleshooting GuideDate Approximate Hours Of Use Service Performed Maintenance NotesWarranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCCall Today For a Free Full Color Catalog