Grizzly G0547 Horizontal Sanding, Curved Sanding, To perform horizontal sanding operations

Page 23

Horizontal Sanding

Horizontal sanding allows you to sand the flat surface of a board.

To perform horizontal sanding operations:

1.Turn the power ON and allow the sander to reach full speed.

2.Place the workpiece against the surface of the sanding belt. Hold the workpiece firmly with both hands but keep fingers away from the sanding surface as shown in Figure 21.

Figure 21. Horizontal sanding.

3.Move the workpiece across the surface of the belt for even belt wear.

4.Use the back stop to prevent the workpiece from being thrown off by the rotation of the sanding belt.

Hold the workpiece firmly when the back- stop is removed to prevent the workpiece from being thrown. Keep bystanders away from the machine while in opera- tion.

5.Remove the backstop from the sander if the workpiece is longer than the sanding bed.

Curved Sanding

Inside curves can be sanded using the curved end of the sanding belt.

To perform curved sanding operations:

1.Turn the power ON and allow the sander to reach full speed.

2.Hold the workpiece against the end of the sanding belt. Move the workpiece slowly across the entire surface of the belt as shown in Figure 22.

Figure 22. Sanding an inside curve.

 

 

 

 

 

 

 

 

 

 

 

 

G0547 Combo Sander

-21-

Image 23
Contents Model G0547 Combo SanderPage Table of Contents Safety Instructions for Power Tools SafetyLength Grip the Workpiece with Both Hands Additional Safety Instructions for the G0547 Combo SanderIntroduction Volt Circuit Requirements110V Operation GroundingExtension Cords Machine Features Description SET UPUnpacking Parts InventoryHardware Recognition Chart Working Clearance Weight LoadSite Considerations To mount the sander to a workbench Beginning AssemblyTo install the disc guard Mounting SanderSquaring Table Installing Disc TableTo install the disc table Attaching Sandpaper Aligning Table Adjusting Miter GaugeTo install the back stop Adjusting Belt AngleInstalling Back Stop Installing Sanding BeltTo connect your machine to a dust collection system Adjusting Sanding Belt TrackingInstalling Dust Collection Hose To test the trackingOperations General Power SwitchTo perform miter sanding operations Disc SandingMiter Sanding Angle Sanding Installing Table on Sanding BeltTo perform curved sanding operations Horizontal SandingCurved Sanding To perform horizontal sanding operationsSchedule MaintenanceMaintenance Safety Lubricating Sleeve Bearings Replacing Drive BeltExtra A/O Belts Aftermarket AccessoriesReference Info GeneralMachine Data Sheet Parts Breakdown Description Trouble Cause Correction Troubleshooting GuideDate Approximate Hours Of Use Service Performed Maintenance NotesWarranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCCall Today For a Free Full Color Catalog