6.Now install the Dust Port using the Hex Bolts and Washers as shown in Figure 9.
Figure 9.
7.The last step involves mounting the working table. Loosen the two setscrews in the cast iron base. Insert the table support rod into its hole, making sure the flat portion of the shaft is facing the setscrews. Tighten the setscrews. Figure 10.
Figure 10.
8.Now slide the working table assembly onto the support shaft and tighten the setscrews. Keep in mind that there should be a 1/16" gap between the sanding disc and the table.
Figure 11.
Figure 11.
G1014Z Combination Sander |