Changing Discs |
| Table tilt |
|
|
|
|
|
|
To replace the sanding disc:
1.Remove the Working Table.
2.Remove the Cover Knob and open the Cover Door.
3.Peel off the old Sanding Disc. Remove the backing from the new Disc, center it and press it firmly into place.
4.It may become necessary to remove the Cast Iron Disc from the Motor Shaft because the Sanding Disc cannot be peeled off or the Cast Iron Disc requires cleaning. See page 10.
1.Loosen the table lock knob. Figure 19.
2.The table can now be set to any angle between
Figure 19.
|
|
|
|
|
|
|
|
|
|
|
|
G1014Z Combination Sander | |||