Clean up |
| Site Considerations |
|
|
|
|
|
|
The work table and other unpainted parts of the Model G1014Z are coated with a waxy oil that protects them from corrosion during shipment. Remove the protective coating with mineral spir- its and cloth rags. Do not use gasoline or other petroleum based solvents because of their extremely low flash points. Do not use chlorine- based solvents – if you happen to splash some onto a painted surface, you’ll ruin the finish.
WARNING!
Follow the safety rules listed below when working with solvents:
1.Read and follow all directions and warnings on the solvent label.
2.Work only in a well ventilated area.
3.Do not work near any type of open flame (e.g., pilot lights, kerosene heaters, and so on).
4.DO NOT smoke while working with flamma- ble material.
5.Paper towels and rags from the cleaning process are extremely combustible. Dispose of waste towels so they do not create a fire hazard.
1.Floor Load: Your G1014Z Sander repre- sents a medium weight load in a small foot- print. Most commercial floors are suitable for the Model G1014Z. Some residential floors may require additional build up to support both machine and operator.
2.Working Clearances: Consider existing and anticipated needs, size of material to be processed through each machine, and space for auxiliary stands, work tables or other machinery when establishing a loca- tion for your sander.
3.Lighting and Outlets: Lighting should be bright enough to eliminate shadow and pre- vent eye strain. Electrical circuits should be dedicated or large enough to handle amper- age requirements. Outlets should be located near each machine so power or extension cords are clear of
G1014Z Combination Sander |