Curved Sanding |
| Disc Sanding |
|
|
|
|
|
|
To sand curves, use the end of the belt arm. Hold the workpiece firmly and apply light, even pres- sure to the belt. To avoid excessive loading of the belt in one area, move workpiece slowly across entire surface of belt. Figure 21.
1.Loosen table lock knob and tilt work table to desired angle. Tighten lock knob.
2.Ease workpiece into the half of the disc that spins down toward the table. Figure 22.
3.When using the table for beveled sanding operations, smaller workpieces are at risk of getting jammed between the disc (or vertical belt) and the table. Figure 23.
Figure 21.
Figure 22.
Figure 23.
|
|
|
|
|
|
|
|
|
|
|
|
G1014Z Combination Sander | |||