Clarke C2K Series manuel dutilisation 120VOLTMACHINES, Extensioncords

Grounded

Outlet

Grounded

Outlet

GroundingBox

Pin

(United States, Mexico and Canada)

Figure 4

Toma corriente con polo de tierra.

	Tapa del
	toma
Terminal	corriente
	con polo
de tierra
	de tierra.
	Figure 4a

Prise de courant avec mise à la terre

	Boîte de
Broche de mise	sortie
	mise à la
à la terre.
	terre
	Figure 4b

120VOLTMACHINES

Instructions for connection to the power

supply and the electrical ground.

This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electrical shock. This product is equipped with a cord having an equipment-grounding conductor and ground- ing plug. The plug must be inserted into an appropriate oulet that is properly installed and grounded in accor- dance with all local codes and ordinances.

WARNING: Improper connection of the equip- ment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

This product is for use on a nominal 120 volt circuit and has a grounding attachment plug that looks like the plug illustrated in Fig. 4. Make sure that the product is connected to an outlet having the same configuration as the plug. No adaptor should be used with this product.

WARNING: Topreventpossibleelectricshock, protect the machine from rain. Keep the machine in a dry building.

WARNING: Topreventpossibleelectric shock, always use a 3-wire electrical system connected to the electrical ground. For maximum protection against electrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electrical contractor.

WARNING: Do not cut, remove or break the ground pin. If the outlet does not fit the plug, consult your electrical contractor.

WARNING: Have worn, cut or damaged cords replaced by an authorized service person.

EXTENSIONCORDS

Use only an approved extension cord with three conductors, a plug with three terminals, and a connector body with three holes. The machine has a power cord with wire size 14 AWG (AWG means American Wire Gauge).

WARNING: If you use an extension cord, use an extension cord with minimum wire size 12 AWG. Do not use an extension cord longer than 50 feet. Do not join two extension cords.

Page -20 - CLARKE TECHNOLOGY Operator's Manual - C2K Series 120V