Specifications
Electrical Requirements | 110 V~ / 60 Hz / 6 A | |
(load) | ||
| ||
Motor No Load Speed | 2 Speed (2800/ 3300) | |
Arbor Diameter | 7/8” | |
Spindle Thread | 5/8” - 11 |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
List of contents
Part(s) | Description | Q’ty |
48 | Polishing Bonnet | 2 |
46 | Backing Pad | 1 |
34 | Side Handle | 1 |
47 | Flange Nut | 1 |
Set Up Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
| Risk of accidental starting; resulting in serious personal | |
WARNING | ||
injury. Turn the Power Switch of the tool to its “OFF” | ||
| ||
| position and unplug the tool from its electrical outlet before | |
| assembling or making any adjustments to the tool. |
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.Attach the Side Handle (34) to the Housing (16). Hold the Polisher upside down resting in your hand with your finger on the Stop Pin (3). Depress the Stop Pin (3) so that the Output Shaft (42) won’t turn.
2.Insert the knobs protruding from the Wrench (49) into the recessed holes on the Flange Nut (47). Loosen and remove the Flange Nut (47) by turning it coun- terclockwise. Set the Backing Pad (46) on the Output Shaft (42). Replace the Flange Nut (47) by turning it clockwise.
SKU 41213 | For technical questions, please call | Page 11 |