Operating Instructions
Controls
ON/OFF Switch (24)
Polishing
1.Place a clean Polishing Bonnet (48) securely onto the Backing Pad (46). Tie it securely using the drawstring. Make sure to tuck any excess string inside the Bonnet
Note: Prior to waxing or polishing a vehicle, make sure it’s surface has been thoroughly washed, and is free of dust, dirt, oil, grease, etc.
2.Apply about two tablespoons of wax (not included) evenly on the Polishing Bon- net (48). Do not apply the wax directly to the surface of the vehicle. The amount of wax needed will vary according to the size of the vehicle being waxed.
IMPORTANT
Carefully inspect the condition 
WARNINGbefore use and check the accessory continually during use. If any damage is noted, stop immediately and replace the accessory
Carefully inspect the condition of the accessory before use and check the with an undamaged one. Harbor Freight Tools cannot be held responsible for damage
accessory continually during use. If any damage is noted, stop immediately caused by using a damaged accessory on this tool.
and replace the accessory with an undamaged one. Harbor Freight Tools cannot be held responsible for damage caused by using a damaged accessory on this tool.
Note: Avoid using too much wax. For additional applications of wax to the Polish- ing Bonnet (48), reduce the amount of wax. The Polishing Bonnet (48) will not absorb as much wax in subsequent applications.
3.Plug the Power Cord (33) into an electrical extension cord (not included). Then, plug the extension cord into a grounded, GFCI, 120 volt, electrical outlet.
Note: Always start and stop the Polisher while it is held firmly against the surface of the vehicle. Failure to do so may result in the Bonnet being thrown from the Backing Pad (46).
SKU 41213 | For technical questions, please call | Page 13 |