Chicago Electric 41213 operating instructions For technical questions, please call

Page 12

3.Depress the Stop Pin (3). Using the Wrench (49), Tighten the Flange Nut (47) by turning it clockwise until firmly in place. See Figure 1 below.

4.Wrap a clean Polishing Bonnet (48) on top of the Backing Pad (46). Tie it se- curely using the drawstring. Make sure to tuck any excess string inside the Bon- net. See Figure 2 below.

5.For sanding, place a sanding disk with a hole in the center onto the Backing Pad and secure it with the Flange Nut (47). See Figure 1 below.

Figure 1

Flange Nut (47)

Backing Pad (46 )

Output Shaft (42)

Stop Pin (3)

Side Handle (34)

Housing (16)

Figure 2

Polishing Bonnet (48)

SKU 41213

For technical questions, please call 1-800-444-3353.

Page 12

Image 12
Contents For technical questions or replacement parts, please call Distributed exclusively by Harbor Freight ToolsSave This Manual For technical questions, please callGeneral Safety Rules Work area safetyElectrical safety Personal safetyPower tool use and care Specific Safety Rules . ServiceVibration Hazard SKU For technical questions, please callSKU For technical questions, please call For technical questions, please call Grounding Grounded Tools Tools with Three Prong PlugsDouble Insulated Tools Tools with Two Prong Plugs Extension Cords See Outlets for 2-Prong PlugSee Table a Symbology FeetSpecifications Set Up InstructionsList of contents AssemblyFor technical questions, please call Operating Instructions ControlsPolishing For technical questions, please call Sanding Maintenance And Servicing Cleaning, maintenance, and lubricationTroubleshooting Parts List Description QtyAssembly Diagram Limited 90 DAY Warranty Record Product’s Serial Number Here