CONNECT WELDER GROUND
Attach the ground clamp to the work piece making sure that the work piece is cleaned of dirt, oil, rust, scale, oxidation, and paint at the point of connection. It is best to connect the ground clamp directly to the work piece and as close to the cut as possible. If it is impractical to connect the ground clamp directly to the work piece, connect it to metal that is securely attached to the work piece, but not electrically insulated from it. It is possible to cut ungrounded pieces, but cutting capacity is limited and consumable life is decreased.
CAUTION!
RISK OF ELECTRONIC COMPONENT DAMAGE!
If the ground clamp is being connected to an automobile or other equipment with
OPERATION
ARC STARTING
When the trigger is pressed, compressed air flows through the torch. When it reaches the end of the torch, the electrode is pushed back away from the nozzle by the force of the air. When the gap between the electrode and nozzle becomes great enough, an arc is created and quickly becomes a plasma arc.
DUTY CYCLE
The duty cycle rating is expressed as a percentage of an industry recognized cycle, based on a 10 minute working time period. The duty cycle rating of a plasma arc cutter tells the operator what portion of the 10 minutes of working time the cutter can be used for cutting and what portion of the time the cutter must be allowed to rest and cool. Your unit has a duty cycle rating of 35%. This means that out of the 10 minute working time period, you may cut for three and one half minutes, but must allow the cutter to cool for the remaining six and a half minutes of the working time period.
SAFETY INTERLOCKS
When air pressure is not sufficient to blow the electrode back from the nozzle, current will not be allowed to the torch for cutting. Some common reasons for low air pressure are:
1.The compressed air source pressure or the air regulator on the cutter is set too low.
2.The consumable parts at the end of the torch are not installed at all or not installed properly.
3.Any filter being used with the cutter is plugged and needs to have a new filter element installed.
4.A thermal switch is also provided in the cutter to prevent overheating. Exceeding the cutter duty cycle rating, or holding the torch more than 1/16 inch from the workpiece normally causes overheating.
For all of these conditions, an error message will be indicated on the digital display or the LEDs on the unit to indicate the problem.
GENERALMAINTENANCE
This plasma arc cutter has been engineered and manufactured to give many years of
1.Inspect and replace all cutting torch consumables in a timely manner.
2.Periodically, unplug the power cord from the ac power source and remove the cover from the plasma cutter.
Always check that the torch consumables are in good shape and not worn out. This is the biggest single thing to assure the best cutting performance.
18