Adjusting the screw-driving depth
Turn the screw depth adjusting dial upward to achieve more depth.
Turn the screw depth adjusting dial downward to achieve less depth.
Four clicks make an increment of 1 mm.
Approximate standard depths (0 mm deep)
Countersunk andPan-head screws
Attaching and detaching the specific connecting screws
Attaching
Place the VISROPE STRIPS in the direction shown in the figure.
Detaching
Hold down the connecting screw
Draw out the VISROPE STRIPS.
Tightening the screws
Set the screwdriver's trigger switch to the ON position.
Press the lock button for continuous screw tightening.
Apply and push the tool perpendicular onto the work. The CH7241 stops at the end of a stroke. The screwdriver's clutch is then activated to completely tighten up the screw.
Troubleshooting
Two screws fed at once, or screw jammed and stuck.
Hold down the connecting screw
Lower the feed lever.
Make sure the screws go smoothly, and draw out the
VISROPE STRIPS.