Makita AR410HR dimensions Magazine Section

Page 14

P 14/20

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-6 Magazine Section

DISASSEMBLING

1)Separate Magazine section from Housing as described in Fig. 26.

2)The Magazine section can be disassembled as described in Fig. 27.

Fig. 26

Magazine section can be separated from Housing by removing

M5x28 Hex socket head bolt, Flat washer 5, M5 Hex nut and Hook.

M5x28 Hex socket head bolt

Flat washer 5

Magazine section

Hook

M5 Hex nut

Fig. 27

Stop ring E5 is the stopper for Pin 5 (hinge pin).

Therefore, by removing this Stop ring using slotted screwdriver from the rear of Magazine complete, Pin 5 can be removed from Magazine complete, and consequently, Magazine cap complete is separated from Magazine complete.

Pin 5

Stop ring E5

Magazine complete

Stop ring E5

Magazine cap complete

Image 14
Contents Standard equipment SpecificationOptional accessories Necessary Repairing Tools RepairDISASSEMBLY/ASSEMBLY Fastening Torque for Bolts ans ScerwsTop Cap Section DisassemblingCylinder stay Rear side Front sideNotch Head valveDriver Bit With the stepped face up Correct WrongCylinder Section Air Motor Section Round end of Rotor shaft Outer separatorInner separator Round end Removing Spring pin 2.5-5 from DrumRemoving Ball bearing 689ZZ from Lower drum cap Rotor shaftTop view Hole B Hole a insertion hole for Driver bitHole a Ribs a Repair DISASSEMBLY/ASSEMBLY 3-5. Air Motor Section Magazine Section Ring Trigger Valve SectionDo not remove This Spring pin 213984-5With one side Painted whiteAdjuster, Contact Arm Assembly Closed side Open side Closed sideDriver Guide, Feed Piston Inlet Cap, Plug Do not turn Adjust cap because it is Factory adjustedAdjust cap