Makita AR410HR dimensions Driver Bit

Page 6

P 6/20

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-2. Top Cap Section

ASSEMBLING

3)Assemble Head valve and Cylinder stay to Top cap (left in Fig. 8); assembling of Top cap section is now completed. Then assemble Top cap section, Top cap spacer and Top cap gasket to Housing as illustrated on right in Fig. 8.

Fig. 8

Assemble Head valve by pressing straight down into Top cap.

Then assemble Cylinder stay to Top cap.

Head valve

Top cap

Top cap spacer and two Top cap gaskets are directional when assembled to Housing.

Make sure that the holes A, B, C are aligned with the hole of Housing.

M5x80 Hex socket head Bolt (4 pcs)

Top cap section

A

Top cap gasket

B

 

Note: Be careful not to fall down the eight Compression springs set in Top cap.

Cylinder stay

Top cap spacer

Top cap gasket

Housing

C

[3]-3. Driver Bit

DISASSEMBLING

1)Disassemble Top cap and Top cap spacer from Housing as described on left in Fig. 3.

2)Disassemble Driver bit as described in Fig. 9.

Fig. 9

Remove Driver bit by pushing it from Driver guide complete side.

Driver guide complete

After removing Rubber ring 19 (white), pull off Pin 3. Main piston and Piston cap can now be removed

as illustrated below.

Rubber ring 19

 

(white)

Piston cap

Pin 3

Driver bit

 

Main piston

 

Driver bit

Main piston

Image 6
Contents Specification Optional accessoriesStandard equipment Necessary Repairing Tools RepairDISASSEMBLY/ASSEMBLY Fastening Torque for Bolts ans ScerwsTop Cap Section DisassemblingCylinder stay Rear side Front sideNotch Head valveDriver Bit Correct Wrong Cylinder SectionWith the stepped face up Air Motor Section Outer separator Inner separatorRound end of Rotor shaft Round end Removing Spring pin 2.5-5 from DrumRemoving Ball bearing 689ZZ from Lower drum cap Rotor shaftTop view Hole a insertion hole for Driver bit Hole a Ribs aHole B Repair DISASSEMBLY/ASSEMBLY 3-5. Air Motor Section Magazine Section Ring Trigger Valve SectionDo not remove This Spring pin 213984-5With one side Painted whiteAdjuster, Contact Arm Assembly Closed side Open side Closed sideDriver Guide, Feed Piston Do not turn Adjust cap because it is Factory adjusted Adjust capInlet Cap, Plug