Makita AR410HR dimensions Hole a insertion hole for Driver bit, Hole a Ribs a, Hole B

Page 12

P 12/20

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-5. Air Motor Section

ASSEMBLING

4)Assemble Air motor section to Housing as illustrated in Figs. 22, 23.

Fig. 22

Driver bit

Hole A: insertion hole for Driver bit

Carrier complete

Internal gear 44

Ribs A: with larger intervening width

1R273

[Top view]

Carrier complete

Hole A

Ribs A

1.First, for easy assembling, make the following adjustment:

Insert Driver bit into Hole A of Carrier complete. Then, by turning Driver bit, set Hole A vertical (or horizontal) to Ribs A of Internal gear 44.

Note: Ribs A cannot be seen when assembling Air motor section to Housing although alignment of Ribs A with Rib B (See Fig.23) of Housing is required.

This adjustment will be able to know the position of Ribs A from that of Hole A.

Fig. 23

2.Hold Housing over Air motor section on 1R273.

In order to fit Rib B (located on Grip side inside Housing) in Ribs A, while watching Hole A through Hole B of Housing, turn Housing or Air motor section so that Hole A is positioned vertical (or horizontal) to Grip.

Put Housing down over Air motor section until it stops.

3.Make sure that Air motor section is properly assembled to Housing by measuring the depth indicated in the illustration below.

The depth will be approximately 43.5mm if properly assembled.

Rib B: located on the inside surface

of Housing end, positioned on Grip side, widest of the four

Housing

Grip

Hole B:

Hole for Driver bit on the end surface of Housing

Hole A

Ribs A

Upper drum cap

Housing

Upper drum cap

approx.

43.5mm

1R273

Image 12
Contents Specification Optional accessoriesStandard equipment Necessary Repairing Tools RepairDISASSEMBLY/ASSEMBLY Fastening Torque for Bolts ans ScerwsTop Cap Section DisassemblingRear side Front side NotchCylinder stay Head valveDriver Bit Correct Wrong Cylinder SectionWith the stepped face up Air Motor Section Outer separator Inner separatorRound end of Rotor shaft Removing Spring pin 2.5-5 from Drum Removing Ball bearing 689ZZ from Lower drum capRound end Rotor shaftTop view Hole a insertion hole for Driver bit Hole a Ribs aHole B Repair DISASSEMBLY/ASSEMBLY 3-5. Air Motor Section Magazine Section Trigger Valve Section Do not remove This Spring pinRing 213984-5With one side Painted whiteAdjuster, Contact Arm Assembly Closed side Open side Closed sideDriver Guide, Feed Piston Do not turn Adjust cap because it is Factory adjusted Adjust capInlet Cap, Plug