Makita AR410HR dimensions Inlet Cap, Plug, Do not turn Adjust cap because it is Factory adjusted

Page 20

P 20/20

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-9. Driver Guide, Feed Piston

ASSEMBLING

Do the reverse of the disassembling steps. (Refer to Figs. 39, 38, 37.)

[3]-10. Inlet Cap, Plug

DISASSEMBLING

Disassemble Plug and Inlet cap as described in Figs. 40, 41, 42.

Fig. 40

Clamp the hex portion of Plug in vise. Then, by turning the machine clockwise,

Plug section can be removed from the machine.

Plug section can be disassembled as illustrated below.

Comical compression spring 5-10

Sheet packing

Plug

 

 

Cap 9

Vise

Plug

Fig. 41

By unscrewing four M5x30Hex socket head bolts,

four parts can be removed from Housing as illustrated below.

Inlet cap with Adjust cap Filter

Inlet cap spacer Inlet cap gasket

M5x30 Hex socket head Bolt (4 pcs)

Housing

Remove O ring 25 from Inlet cap.

Inlet cap with

Adjust cap

O Ring 25

[Caution]

Do not turn Adjust cap because it is

factory adjusted.

Inlet cap

Adjust cap

Fig. 42

Pipe 13 can be removed from Housing by holding the inside of the Pipe with 1R003 then by pulling off Pipe 13 together with Inlet filter.

If it is difficult to remove Pipe 13 using 1R003, remove by striking the end surface of Grip with mallet.

Pipe 13

O Ring 14 [thick]

O Ring 14 [thick]

(213154-6)

(213162-7)

1R003

 

 

Pipe 13

[Caution]

Do not clamp the outside of Pipe 13, or its outer surface will be scratched, causing air leakage.

O Ring 14 [thin] Inlet filter (213162-7)

Image 20
Contents Standard equipment SpecificationOptional accessories Necessary Repairing Tools RepairDISASSEMBLY/ASSEMBLY Fastening Torque for Bolts ans ScerwsTop Cap Section DisassemblingRear side Front side NotchCylinder stay Head valveDriver Bit With the stepped face up Correct WrongCylinder Section Air Motor Section Round end of Rotor shaft Outer separatorInner separator Removing Spring pin 2.5-5 from Drum Removing Ball bearing 689ZZ from Lower drum capRound end Rotor shaftTop view Hole B Hole a insertion hole for Driver bitHole a Ribs a Repair DISASSEMBLY/ASSEMBLY 3-5. Air Motor Section Magazine Section Trigger Valve Section Do not remove This Spring pinRing 213984-5With one side Painted whiteAdjuster, Contact Arm Assembly Closed side Open side Closed sideDriver Guide, Feed Piston Inlet Cap, Plug Do not turn Adjust cap because it is Factory adjustedAdjust cap